アドコン List of Products and Services

This is a device that transmits contact signals using specific low-power wireless technology. The communication range is up to 1000 meters in line of sight, making it suitable for wide areas. Additionally, up to 10 relay units can be used. *Line of sight means that the antennas can see each other. If there are obstacles preventing the antennas from being visible to each other, it is not considered line of sight. *It can only be used in a one-to-one configuration; one-to-N configurations are not possible. Since contact signals are transmitted wirelessly, there are no communication costs involved.

• Monitoring and Control Equipment

Remote monitoring is possible using a standard line (telephone line). There are 4 input signals, and depending on the environment of the reporting destination, both "voice reporting" and "text message reporting" are available. Additionally, you can select the input signals to monitor for each reporting destination. ~ Please check the details in the catalog first!! ~

• Security Sensor Systems

The input signal has 8 contacts, and it is possible to send "voice alerts" or "text message alerts" according to the environment of the reporting destination. Additionally, you can select the input signals to monitor for each reporting destination. ~ Please check the details in the catalog first!! ~

• Facility Management System

The LTE (4G) communication module is built-in, allowing for remote monitoring in environments without a general line. It is possible to use NTT Docomo's LTE (4G) wireless for "voice reporting" and "SMS email reporting," with a maximum of six settings for each.

• Other security systems

- It is a device that transmits contact signals using specific low-power radio. - Remote monitoring and remote control are possible using specific low-power radio. - The transmitter has 8 input signal contacts, and the receiver has 8 output signal points, operating in synchronization with each other. - The reachable distance is approximately 1000 meters at a height of 1.5 meters in an open rural area (however, this is only applicable in environments with low noise and without surrounding interference. The distance may be shorter depending on installation conditions, such as the presence of obstacles like buildings or mountains). - It can only be used in a one-to-one configuration. It cannot be used in a one-to-N configuration.

• Monitoring and Control Equipment

●Prevents unnecessary battery consumption The standby power when the main unit is switched on is approximately 0.3 watts. ●Notifies with sound and buzzer when voltage drops When the battery voltage falls below 11.5V, a warning buzzer (beep beep) sounds every 30 seconds, and the blue light turns on. When the battery voltage falls below 11.0V, an SOS buzzer (beep beep beep beep beep ...) sounds, and the red light turns on. The load will be disconnected within 30 seconds. ●Notifies with sound and buzzer when the heat sink becomes too hot When the temperature of the heat sink exceeds 50°C, an SOS buzzer (beep beep beep beep beep ...) sounds, and the yellow light blinks. If the temperature does not decrease after 60 seconds, the load will be disconnected.

• others

This is a device that warns with a buzzer sound when the small lights or headlights of a vehicle are left on after the key is removed, preventing battery drain. It features a microcontroller and emits an easily recognizable alarm sound, consuming only a few mA of current while the lights are on, making it very energy-efficient. Additionally, the main body case is compact, measuring W30×H20×D40.

• others