Testing Systems×マイクロニクス - List of Manufacturers, Suppliers, Companies and Products

Testing Systems Product List

16～18 item / All 18 items

Displayed results
The relationship between the lower limit of noise level for measuring radiated EMI and antenna gain.

The relationship between the lower limit of noise level for measuring radiated EMI and antenna gain.

In radiation EMI measurements, using antennas with high gain allows for the measurement of lower levels of noise.

■Conducted EMI Test System MR2150 A pre-compliance system for conducted EMI (noise terminal voltage) testing. By using this system for debugging evaluation before conducting the official tests at a certified EMC site, development costs can be significantly reduced. By using a high-gain antenna, lower levels of noise can be measured in radiated EMI (emission) measurements.

  • others

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
Report on the Compatibility of Measurement Data in an Anechoic Chamber

Report on the Compatibility of Measurement Data in an Anechoic Chamber

[Technical Data] EMI Test System MR2300/RF Shielded Room MY5410

■EMI Test System MR2300 Ideal for preliminary compliance testing of official EMI tests, known as "Pre-compliance." This is an integrated system that combines our spectrum analyzer technology, anechoic chamber technology, and antenna technology. ■Anechoic Chamber MY5410 An anechoic chamber optimized for ultra-large EMI tests. It comes standard with a turntable with a diameter of 756mm and a load capacity of 100kg, designed for large EUTs. *For more details, please refer to the PDF materials or feel free to contact us. The MR2300/MY5410 has been developed for pre-compliance use. This allows for the measurement of harmonics from switching power supplies in the 40-100MHz range, which was previously difficult. Below are the measurement results obtained with the MR2300/MY5410, compared with measurements conducted in a 10m anechoic chamber equipped with facilities equivalent to the official site, using the 3m method.

  • others

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
Measurement accuracy of the conductive EMI test system MR2150.

Measurement accuracy of the conductive EMI test system MR2150.

Technical Data: Measurement Accuracy of MR2150 Compared to Compliance System

【Product Introduction】 ■Conductive EMI Test System MR2150 A system for pre-compliance testing of conductive EMI (noise terminal voltage). 1. Importance of EMC Pre-compliance Testing - The significance of EMC pre-compliance testing in product development - Comparison of pre-compliance testing with other EMC evaluation solutions 2. Measurement Accuracy Verification of MR2150 - EMI measurement accuracy of the Spectrum/Signal Analyzer MSA series - Conductive EMI testing of sample EUT - Appropriate measurement methods using MR2150

  • others

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
COPYRIGHT © 2001-2025 IPROS CORPORATION ALL RIGHTS RESERVED.